Changelog for
inkscape-gears-dev-20111211_jw3-1.1.noarch.rpm :
Thu May 9 14:00:00 2013 jwAATTsuse.com
- update URLs,
- renamed inkscape-extensions-gears-dev to inkscape-gears-dev
Fri Apr 12 14:00:00 2013 jwAATTsuse.com
- extended_ranges.patch added
max. 360 teeth was too low for 366 outer wheel of an astrolabium.
- selectable_accuracy.patch
high accuracy of involute is not needed with large tooth counts.
It just gets extremly slow. Allow lowered settings.
- metric_module.patch
Add an option to select metric units system and module, instead
of circular pitch.
Tue Apr 2 14:00:00 2013 jwAATTsuse.com
- an improvement over the original inkscape extension gears
It adds holes to the gear (central hole for the shaft and some radial holes
to make gear lighter).
* More accurate tooth profile. In earlier versions the involute curve was
approximated by only three points; now by 15 (can be modified in the source code)
* Center cross (easy for aligning); off by default, can be turned on
* Pitch circle (easy for meshing; circles should touch for meshing gears);
off by defalut can be turned on
* Info: in the SVG there is now an extra field telling a little about the
gear (easy if you want to make a meshing gear but you forgot the settings used)